Download Product SpecificationThe CUPER is designed for forced air circulation in a room with heat recovery. It is connected to an alternating current network with a voltage of 220-240 V and a frequency of 50/60 Hz. Before installing the product, it is necessary to prepare the outlet of the network cable above the hole in the wall in advance! The device guarantees an influx of fresh air at a comfortable temperature at any time of the year. Heat regeneration is carried out by means of a ceramic heat exchanger, which controls the temperature of the incoming air, making it comfortable.
The heat exchanger heats up or cools down during exhaust, and the supply air heats up or cools down, depending on the outside temperature. That is, in winter, when the Cuper works for exhaust, the air removed from the room heats the ceramic heat exchanger. When working for supply, cool fresh air is heated to a comfortable temperature. In summer, the opposite process occurs: the supply air enters the room slightly cooled. Due to this, there is no need for ventilation, and, accordingly, the costs of heating and air conditioning the room are reduced. CUPER also filters the air, removing dust, pollen and other allergens from it.
Operating temperature: outside - from -30 to +50 °C, indoors - from +1 to +40 °C.
It is controlled by a remote control. It has four operating modes:
• tributary
• hood
• alternate inflow-exhaust
• smart mode
• Works regardless of exhaust systems
• Blocks out street noise
• IR remote control
• Timer for setting up the operation of the
device according to the schedule
• Synchronization of up to 10 devices into a
single ventilation system
• Diameter 125 mm
Operation in smart mode depends on the outside temperature: the colder or warmer the air outside compared to the room, the less the device will work for supply. Supply-exhaust adjustment is carried out by temperature sensors.
It has an automatic mode: when switched on, the Cuper works for inflow, then for exhaust. Then the modes change each other after the set time (60, 70, 80, or 90 sec.).
Operation in smart mode depends on the outside temperature: the colder or warmer the air outside compared to the room, the less the device will work for supply. Supply-exhaust adjustment is carried out by temperature sensors.
It has an automatic mode: when switched on, the Cuper works for inflow, then for exhaust. Then the modes change each other after the set time (60, 70, 80, or 90 sec.).
